Yanmar 6LPA-STP2 Specifiche Scaricare il pdf (Pagina 46)

100

101

[]

(1) Replacing the Fuel Filter

Replace the fuel filter periodically before there

is clogging and the fuel flow is reduced.

① Close the fuel cock of the fuel tank.

② Drain the fuel from the fuel drain cock at the

bottom of fuel filter. See. 5.2.2(2)

③ Remove the connectors of the wiring and

remove the alarm switch using spanner.

④ Remove the fuel filter using filter wrench.

⑤ Tighten the new fuel filter. (Clean the fuel filter

installing surface).

Part No. of the fuel filter: X5186100664

●

Install the alarm switch to the new fuel filter.

●

Apply fuel to the gasket of the new fuel filter.

●

Lightly screw in the fuel filter in position and

tighten it until the gasket comes into

contact with the seat.

●

Manually tighten the filter by a 3/4 turn.

[tightening torque: 14.7~19.6N

m(1.5~2.0 kgf

m)]

●

Connect the alarm switch wiring.

⑥ Fill fuel to the fuel filter. (See 3.2.2)

●

If you spill fuel, wipe such spillage carefully.

●

Start the engine to check for fuel leakage.

(2) Replacing Cooling Water

Cooling performance drops when the cooling water is contaminated with rust and scale.

Even if long life coolant (LLC) is added, the cooling water must be periodically replaced because

the properties of the agent will degenerate. Replace the cooling water periodically.

●

Draining the Cooling Water → See 4.9.1(2).

●

Supplying Cooling Water → See 3.5

5.2.4 Inspection Every 250 Hrs. or 1 yr.

Lube Oil Filter

Tighten

Filter wrench

Loosen

Alarm switch

Removing the water

alarm switch

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 698 699

Commenti su questo manuale

Nessun commento

Yanmar 6LPA-STP2 Specifiche Pagina 46

Commenti su questo manuale

Prodotti e manuali riguardandi Motore Yanmar 6LPA-STP2